Richmond Water Heater Odor Repair

Are you experiencing issues with foul odors coming from the water originating from your water heater? It could happen in certain cases for a couple various reasons. Here is what Water Heater Repair Richmond VA recommends to do to make sure your water smells much better and to get rid of any awful taste fast.

Reasons for Richmond Water Heater Smells?

Bacteria getting in the water system is the most typical cause ones water in the home could have odors. If you home utilizes well water or cities that use wells for the water supply, increases the possibility of this occurring.

With a water heater temperature level setting of 140 degrees or higher will assist in lowering the growth of bacteria inside of the water storage tank.

Exactly How to Remove Stinky Water Smells

The following instructions discuss the best way to use chlorine bleach to clean a water heater.

The electric or gas going to the water heater tank has to first be shut off.

Next, the cold water supply off that leads to the tank needs to be shut off.

Open the hot water faucet of the kitchen sink to enable air to get in the tank.

With a a yard hose hooked up to the storage tank drain valve, drain the water inside the water heater.

Then close the drain valve once it is empty.

The next step is adding the bleach.
If the hose for the cold water travelling into the storage tank is a flexible line, unscrew it from the tank. If not, one will likely need to remove the pressure relief valve, which is more involved. For electric water heaters, one of the elements can be removed.

Use a funnel to put bleach inside the tank.
Use 5 ounces of bleach for each gallon of the tank capability.
So if you have a 50 gallon water heater, you will require 250 ounces of bleach, or close to 2 gallons.

Reinstall the water line or pressure relief valve.

Fill the tank back up with water again.

Close up the hot water faucet of the kitchen faucet as quickly as all the air runs out the line.

Operate all the hot water appliances till the aroma of bleach is evident. We want to kill the germs that are in the water lines likewise, not just within the water heater.

Keep the water in the tank and water lines undisturbed for a couple of hours.

Empty the storage tank once more and refill it. This time allow it to stay for at least 30 minutes and just as before drain it.

Fill the tank back up. Open all of the hot water fixtures and let them run up until the odor of bleach is gone.

For gas water heaters, relight the water heater pilot burner. For electric water heaters, turn the electricity on again.

Also, by changing the anode rods, or perhaps the type utilized can work as the next video demonstrates:

Additionally, by replacing the anode rods, or perhaps the type employed can work as the next video shows:

Odors from Richmond Water Heater

What the Experts Say

According to Soquel Creek Water District, “The smell is the result of four factors that must all be present for the odor to develop. These factors include:

  • A high concentration of sulfate in the raw water
  • Sulfate reducing bacteria, non-toxic to humans (sulfate is reduced to a sulfide state by the bacteria)
  • Little or no dissolved oxygen in the water
  • Hydrogen (a component of water which may be present due to water conditions reacting with the anode)”  Read more here…

Soquel Creek Water District

How is hydrogen sulfide gas produced in a water heater?

A water heater can provide an ideal environment for the conversion of sulfate to hydrogen sulfide gas. The water heater can produce hydrogen sulfide gas in two ways – creating a warm environment where sulfur bacteria can live, and sustaining a reaction between sulfate in the water and the water heater anode.  Read more…

Minnesota Department of Health

Check out some of our other water heater tips in our blog